Seeed Studio 102991674 - CANBed DUAL - RP2040 chip based Arduino CAN Bus dev board with 2 independent CAN Bus interfaces(CAN2.0 & CAN FD)
|
SEEED 102991674
1 kappale kappaletta
Varastossa
Huom: Viimeinen tuote varastossa!
Tulossa:
Seeed Studio 102991674 - CANBed DUAL - RP2040 chip based Arduino CAN Bus dev board with 2 independent CAN Bus interfaces(CAN2.0 & CAN FD)
CANBed Dual is a CAN Bus development board with 2 independent CAN FD interfaces based on RP2040. It uses GD32E103CBT6 as the CAN controller with an operating frequency is up to 133MHz, which is suitable for most embedded applications.
CANBed DUAL, a CAN Bus development board, is based on the RP2040 chip which is the debut microcontroller from Raspberry Pi. It brings signature values of high performance, low cost, and ease of use to the microcontroller space. There are 264 KB of SRAM and 2MB of Flash memory on board. The operating frequency is up to 133MHz, and it contains a 6PIN Terminal and a flexible Micro USB connector where you can either program the board or supply power to the board. The voltage input range is 9-28V which provides a stable 5V/1A output. There are also rich interfaces on board including one I2C, one UART, one SPI interface, three analog input interfaces, and eight digital IO
CANBed DUAL has two independent CAN Bus interfaces which are CAN2.0 and CAN FD, and it uses high-performance GD32E103CBT6 as the CAN controller. With CANBed Dual, you can learn CAN Bus communication, build product prototypes and read the data from the car. Also, as a part of your product, it integrates the processes of designing the MCU and the CAN Bus, and you only need to complete other hardware designs.
CAN stands for Controller Area Network, it is used to allow microcontrollers and devices to communicate with each other within a vehicle without a host computer which allows for control and data acquisition. These devices are also called Electronic Control Units (ECU) and they enable communication between all parts of a vehicle.
Parameter | Details |
MCU | RP2040 |
Processor | Dual ARM Cortex-M0+ |
Clock Speed | flexible clock running up to 133MHz |
Flash Memory | 2MB |
RAM | 264KB |
Operate Voltage | 9-28V |
Output Current @3.3V | 1A |
Input Interface | sub-D |
Klikkaa tarkemmat tiedot | |
Valmistaja | Seeed Studio |
Valmistajan malli | 102991674 |
Prosessori | ARM Cortex-M0+ (RP2040) |
Kellotaajuus | 133MHz |
Muisti RAM | 264KB |
Muisti EEPROM | ei |
Muisti FLASH | 2MB |
Joy-IT rb-camera-WW - Raspberry Pi...
39,88 €
Seeed Studio 102991321 - Longan CANBed -...
40,07 €
34,92 €
0,64 €
Joy-IT JT-AT34 - USB-monitoiminen jännite- ja...
23,70 €
Kemo S005 - harrastuskäyttöön lajitelma...
5,20 €
Kemo S009 - harrastuskäyttöön lajitelma...
5,90 €
Seeed Studio 110990028 - Grove - 4 pin Female...
6,30 €
Monia eri pituuksia.
5,90 €
Raspberry Pi Pico W on uusi...
15,40 €