Pico Decker (Quad Expander)

Quadruplicate your GPIO pins and attach up to four add-ons to a single Raspberry Pi Pico with our formidable Pico Decker expander board!

Struggling to choose between Pico add-ons? Mix and match up an epic stack of functionality and plug in up to four Pico Packs or Bases at once*, or use the four sets of fully labelled male GPIO pins to easily attach other devices, jumper wires or circuitry - very useful for prototyping. We've also included some little rubber feet to keep everything solid, four M2.5 mounting holes and some particularly whimsical Routemaster bus inspired artwork on the back.

A Raspberry Pi Pico is not included.

Features

• One landing area with labelled female headers for attaching to your Pico.
• Four landing areas with labelled (mirrored) male headers for attaching add-ons.
• 4x M2.5 mounting holes.
• 4x rubber feet
• Compatible with Raspberry Pi Pico.
• 99% assembled - just need to stick on the feet!
• No soldering required.
• Dimensions: approx 148mm x 52mm x 13mm (L x W x H, including feet and headers)

Notes

• * You'll need to check for data pin conflicts when using multiple Pico add-ons - the shop page for the add-on in question will list what pins it uses.
• * If you need to plumb a Pico Base into Pico Decker, you'll probably want to do it via some male-female jumper jerky to keep things manageable and to stop everything from being quite so upside-down!
• The Pico Packs shown in the photo are not included