Adafruit AW9523 GPIO Expander and LED Driver

Description

GPIO expanders work like this: you have a board with some number of GPIO but not enough for your project - maybe you need more buttons or LEDs. You could upgrade to a board with massive number of GPIO like the Grand Central, or you could pop on one of these boards. Connect it over I2C and then you can send/receive I2C commands to control the GPIO pins to write and read them. It's going to be slower than direct GPIO access, but maybe that doesn't matter if it takes a millisecond instead of a microsecond. You only need the two I2C pins, and you can even share the I2C port with other sensors and devices. Heck, you can even add more expanders for massive I/O control!

The AW9523 is a twist on the common I2C expander:

• First up, its very affordable - who doesn't love that?
• It has 16 I/O pins, that'll double most boards' pin count
• Four I2C address options, so you can connect 4 expanders to one bus
• Each pin can be an input or an output
• IRQ output can alert you when input pins change value
• This chip does not support internal pull-ups or pull-downs, you will need to add an external resistor if you need one
• However, it does have 8-bit linear constant-current LED dimming support so you can connect LEDs without resistors and have great looking dimming without PWM
• The first 8 pins can be configured as open drain (as a group)

Of course, you can control any buttons or other I/O with the pins - we just think this board is particularly suited to LED driving. There's also an interrupt output, you can enable the pin-change IRQ for any pins so you can be notified when its time to read the I/O states.

Note: You may get an off-white or black JST connector.

AW9523 Features

• 16 multi-function I/O, each for LED drive (current-source dimming) or GPIO mode
• 256 steps linear dimming in LED drive mode
• Any GPIO can be configured as an input or an output independently
• Support interrupt, 8us deglitch, low-level active
• Standard I2C interface, AD1/AD0 select I2C device address
• SDA, SCL, SHDN, and all GPIO can accept in 1.8V logic input
• ESD protection: ±4000V HBM (MIL-STD-883H Method 3015.8 standard）
• Latch-up ：±450mA（ JEDEC STANDARD NO.78C SEPTEMBER 2010 standard）
• Supply shutdown function, low-level active
• 2.5V~5.5V power supply
• I2C address default 0x58 (can be 0x59, 0x5A or 0x5B)

Learn

• Primary Guide: Adafruit AW9523 GPIO Expander and LED Driver
• Raspberry Pi Pico and LED Arcade Button MIDI Controller
• Adafruit nOOds Überguide
• AW9523 English Datasheet

Video